Reviews over the
BBB Cycling BracketKit BTL-95

4.1 / 5

Average from 81 reviews

5		5 reviews
4		10 reviews
3		1 review
2		3 reviews
1		3 reviews

Photos from customers

Sort by:

1 / 5

Not compatible with SRAM GXP 22/24 mm

- Roeland, 16 December, 2024

Purchased to remove/install BB86 bearings (22/24 mm) on a road bike with SRAM GXP bottom bracket. The little tool to remove the bearings is impractical. The blades that should support the bearing on the inside shoot through when pressure is applied (attempts to stop the blades with a 22 mm bushing were in vain). I did not manage to remove the bearings with this tool. In the end, I bought the parktool BBT-90.3 with which it was a piece of cake (I can recommend it to everyone). The bearing press for installing the bearings is fine. In summary, the combi set seems handy but for SRAM GXP bracket with 22/24 mm bearings not suitable in my opinion. Bad buy!

Pros & Cons

Bearing press functions fine

Neat storage case

Cheap is expensive

Not for SRAM XDS bottom bracket with 22/24 mm bearings

Automatic translation

1 / 5

Poor toolkit

- Tom, 15 May, 2021

1 bearing did not get out. Extrusion tool sucks. Am now 2x as expensive. Looking for a better tool.

Pros & Cons

Execution tool is worthless

Automatic translation

1 / 5

Very clumsy mediocre removal tool.

- Menno, 6 April, 2021

tool to remove your old bearings functions moderately to poorly. 3 tabs held together by a rubber band slide over a tapered end which causes the tabs to come out. For the removal of the first bearing it works, after some fiddling. I can't get the last bearing out at all because the shaft can no longer be properly centered and therefore there is no more even pressure on the inside of the cup. Just buy a separate press and rocket tool.

Pros & Cons

Nertte box.

concept of the removal tool

Automatic translation