Reviews over the
Vision Team 30

Vision Team 30
4.4 / 5
Average from 118 reviews
5
28 reviews
4
9 reviews
3
4 reviews
2
2 reviews
1
4 reviews

Photos from customers

1 / 5

I will not buy again

- Jon, 13 November, 2022

After 200 kms and a spoke breaks, they are not responsible.

Automatic translation

1 / 5

A BIG disappointment, the Vision brand and Mantel's service!!!

- Eric, 25 April, 2022

I was looking for a set of wheels to train through the winter months. After 5 months from October the body appeared to be stuck. I have worn out several wheels but I have never experienced this before. I thought Vision was a good brand. I called Mantel customer service, answer was that I could bring the wheel in, then they would check what the problem was and if it could be repaired under warranty. That turned out to be a setback. Mantel blamed it on salt and brine, I only rode in dry weather! The wheel is repaired and I can pick it up at the store in Utrecht. Costs total including a tank of gas €153.- If I look at reviews at other webshops here the same problem with this type of Vision wheel. At the other webshops replaced under warranty. So you know where I will store in the future.......

Pros & Cons

Cheap (too) is expensive
bad service Mantel
defective after 5 months
No warranty at Mantel
poor quality
Poor quality body
Automatic translation

1 / 5

Zijn geen wielen voor winterse omstandigheden

- Wil, 21 January, 2022

de afdichting van deze wielen zijn zeer matig. heb ze 2 jaar in bezit . Lagers en body moeten vervangen worden

1 / 5

Worthless even for a training wheel.

- Glenn, 12 October, 2020

Bought this set last year to get through the winter months. New out of the box the rear wheel was already twisted. So I recalibrated the wheels myself. Cycled from October to January in all kinds of weather. During the first training race in January, I noticed that the bike did not shift well anymore. There was a lot of play on the body. Closer inspection showed that the bearings were already completely rotten. Maintenance cannot be done at home because you need serious workshop tools to get the body off the hub (failed) Knowing that the sealing of these wheels is very poor and maintenance is very labor intensive, decided to give up this wheelset. Very poor value for money

Pros & Cons

Tubeless
wide rim
factory quality control
hub quality
maintenance cannot be performed
poor bearing seal
price/quality ratio
Automatic translation