SRAM Pro Bleeding Kit

It is not so easy to carry out the bleeding. Once you've found the video, you'll be fine. The material is great.

I wasn't sure if this would work with the Rival Etap AXS but so it does. You just have to use the two identical syringes. The other is for calipers with a bleed port. Lies much better in the hand than the hydro kit and you still have to buy DOT fluid there. With that kit you can also go too hard and pull air back into the syringe. Not with this one Once you know what you are doing you are ready in 25 minutes from an assembled bike that doesn't brake to an assembled bike that brakes again. Tips: - Slide the clips to close down a bit. Then you can put them on with one hand. - Check beforehand whether you have a bleedport or not - Keep a sprayer with water/soap or isopropyl with you - Only push and pull on the handlebar sprayer. - Rinse with water/soap (or some isopropyl) and then put in a plastic bag with a dry rag next to it

Pros & Cons

I was looking for a bleeding kit to replace my old one with this one I can bleed my brakes properly again in a jiffy

Pros & Cons

After instructional film good to do Beware of spilling dot 5 fluid because of paint damage

Pros & Cons

After a disappointing service at the local bike shop, I decided to do my brakes myself. The SRAM video on Youtube explains excellently how to bleed the brakes and the set itself works perfectly. My brakes have never felt so tight after bleeding/refreshing! The SRAM bleeding edge adapter (connection to the caliper) also works very nicely compared to other brake systems.

Pros & Cons