Reviews over the
Schwalbe High Pressure Race
Photos from customers
5 / 5
Excellent product
Very smooth delivery.
Pros & Cons
4 / 5
Satisfactory but could be slightly thinner
Does not fall into the gutter of the rim making it slightly too wide. I had determined the desired width beforehand with a piece of tape (pressed into the gutter). That might make putting on the outer tyre more difficult.
Pros & Cons
1 / 5
Worthless
Worthless product. Valve hole is not in the centre so the ribbon does not cross the centre of the rim. This causes the rim to stand up and the sharp edge of the plastic rim tape to wear into the inner tube. So this also resulted in a puncture. The place where the tape is stuck together also has sharp edges. Would be compatible with racing, but in my opinion too small for rims with >19mm inner diameter. This rim tape has not been thought through. For me just another tape.
Pros & Cons
3 / 5
Fine for flat rim bed, not for rim bed in gutter shape.
This non-adhesive rim tape unfortunately shifts continuously, causing it to partly creep onto the shoulder of the rim when fitting the tyre. As a result, spoke holes are barely covered in those areas and the tyre cannot be fitted properly; the rim tape is partly between the shoulder and tyre making it impossible to plop it into place and the tyre bulges. This rim tape seems fine to me for a flat rim bed, but certainly not for a gutter-shaped rim bed with shoulders.
Pros & Cons
5 / 5
Great product
Does what it needs to do
Pros & Cons
5 / 5
Good company, neatly delivered. Am very satisfied with this company.
As in the past, the products were delivered perfectly as agreed.
5 / 5
Doing well.
So far the product seems to be working well, fine purchase.
Pros & Cons
5 / 5
I never use others, on my next bike they will come again.
Fits 100% in my rim, it will sit there for years for now.
Pros & Cons
5 / 5
Good value for money.
I installed these rim strips on my Mavic Cosmic aluminium, easy installation with just a screwdriver, please see the various videos on the internet for installation. For information, if your rim width is 17mm inside, you need to use a maximum of 16mm for the rim base and no bigger.